C-2 Calibration Programs
Introduction
This appendix includes a calibration program written in BASIC to help you calibrate the
Model
2400, as well as an example program that demonstrates how to request calibration
constants. Refer to Section 2 for more details on calibration procedures, equipment, and
connections.
Computer hardware requirements
The following computer hardware is required to run the calibration programs:
• IBM PC, AT, or compatible computer.
• Keithley KPC-488.2, KPS-488.2, or KPC-488.2AT, or CEC PC-488 IEEE-488 inter-
face for the computer.
• Two shielded IEEE-488 connecting cables (Keithley Model 7007).
Software requirements
In order to use the calibration programs, you will need the following computer software:
• Microsoft QBasic (supplied with MS-DOS 5.0 or later).
• MS-DOS version 5.0 or later.
• HP-style Universal Language Driver, CECHP.EXE (supplied with Keithley and CEC
interface cards listed above).
Calibration equipment
The following calibration equipment is required:
• Hewlett-Packard HP3458A Digital Multimeter.
See Section 2 for detailed equipment specifications.
To Next Page
Loading...
