Keithley 2611B User Manual

Safety
Introduction
Models 2611B, 2612B, and 2614B
System SourceMeter Instruments
Quick Start Guide
Models 2611B, 2612B, and 2614B
System SourceMeter Instruments
Quick Start Guide

Keithley 2611B Specifications

General

Type	Source Measure Unit (SMU)
Channels	1
Current Resolution	10 pA
Voltage Resolution	100nV
Communication Interface	USB, GPIB, Ethernet
Display	5 inch TFT LCD
Voltage Range	±200V
Current Range	±3 A

Summary

Safety Precautions

Power and Environmental Specifications

Introduction

Unpack and Inspect the Instrument

Connect the Instrument

Important Test System Safety Information

Key safety guidelines for system connections and operator protection.

Install the Instrument

Connect Line Power

Steps to connect the instrument to AC power, including voltage compatibility.

Turn On the Instrument

Power-up Sequence

Test the Instrument

Step 1: Set Source Function, Range, and Level

Configures the instrument to source voltage and sets the range.

Step 2: Set the Source Limit

Sets the current limit for the voltage source.

Step 3: Set Measurement Function and Range

Configures the measurement function to voltage and sets the auto range.

Step 4: Turn the Output On

Activates the instrument's output for measurements.

Step 5: Observe Measurements

Checks if the measured voltage matches the set source value.

Step 6: Turn the Output Off

Deactivates the instrument's output after measurements are completed.

FAQs

Next Steps