Operating the instrument on an incorrect line voltage
may cause damage to the instrument, possibly
voiding the warranty.
To connect line power:
1. Make sure the front-panel power switch is in the off (0) position.
2. Connect the socket of the supplied power cord to the power
connection on the rear panel.
Connect power cord
3. Connect the plug of the power cord to a grounded AC outlet.
Turn on the instrument
Turn on the instrument by pressing the front-panel POWER switch
to the on (|) position.
The Series 3700A instrument must be turned on and allowed to
warm up for at least two hours to achieve rated accuracies.
Power switch
Safety
Unpack Connect
FAQs
Next steps
Introduction Test
To Next Page
Loading...
