To Next Page

To Previous Page

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual

11-316 3700AS-901-01 Rev. D/June 2018

Example 3

scan.create("3001:3010", "testDCV")

For this example, assume testDCV is a

previously defined user DC volts

configuration.

Clears the old scan list and creates a new

scan list with each channel (1 to 10 on

slot 3).

Each channel uses the DMM configuration

associated with testDCV.

Example 4

scan.create("")

for chan = 3001, 3010 do

scan.add("" .. chan, "testDCV")

scan.add("" .. chan, "test2wire")

end

For this example, assume testDCV is a

previously defined user DC volts

configuration, and test2wire is a

previously defined user 2-wire ohm

configuration.

This loops through the channels, adding

channels to the scan list. The first time, it

adds "testDCV" for a channel. The second

time, it adds "test2wire" for that channel.

The first parameter ("" .. chan) converts

the chan number to a string.

Clears the old scan list and creates a new

scan list.

Loops through channels 3001 to 3010.

Adds channels 3001 through 3010 to the end

of the existing scan list.

Also see

dmm.getconfig() (on page 11-181)

dmm.setconfig() (on page 11-227)

scan.add() (on page 11-309)

scan.reset() (on page 11-324)

Scanning and triggering (on page 5-23)

Keithley 3730 Reference Manual

Other manuals for Keithley 3730