Need help?Do you have a question about the Keithley 2100 and is the answer not in the manual?
General| DC Voltage Range | 100 mV to 1000 V |
|---|---|
| AC Voltage Range | 100 mV to 750 V |
| Resistance Range | 100 Ω to 100 MΩ |
| Continuity | Yes |
| Diode Test | Yes |
| Frequency Range | 3 Hz to 300 kHz |
| DC Voltage Accuracy | 0.0035% |
| DC Current Range | 100 µA to 10 A |
| DC Current Accuracy | 0.05% |
| AC Current Range | 100 µA to 10 A |
| Frequency Accuracy | 0.01% |
| Capacitance Range | 1 nF to 10 mF |
| Temperature Range | -200 °C |
| Connectivity | RS-232 |
| Type | 6.5-digit digital multimeter |
General information about the Model 2100 Digital Multimeter.
Highlights the key features and capabilities of the Model 2100.
Details the technical specifications and performance of the Model 2100.
Provides an overview of the Model 2100 features and basic usage.
Guides users through the initial setup process for the multimeter.
Introduces the main components of the Model 2100.
Explains how to perform DC and AC voltage measurements.
Details how to measure DC and AC currents.
Covers both 2-wire and 4-wire resistance measurement methods.
Explains how to measure frequency and period.
How to use the continuity test function.
Instructions for testing diodes.
Information on measuring temperature using RTDs.
Guide to configuring measurement functions and parameters.
Discussion of the triggering system and options.
Explains the eight available math functions.
System-level configurations affecting measurements.
Guides on setting up remote control via USB using software.
Introduction to SCPI commands for controlling the multimeter.
Overview of triggering options for remote control.
SCPI commands for system-level operations.
How errors are retrieved and managed by the multimeter.
Lists and describes error codes related to command execution.
Identifies errors that may occur during self-tests.
Detailed technical specifications for the Model 2100 multimeter.
Explanation of the SCPI command language structure.
How to use the MEASure? command for measurements.
How to use the CONFigure command to set up measurements.
Commands for configuring measurement functions and parameters.
SCPI commands for performing math operations.
SCPI commands related to triggering measurements.
SCPI commands for system-level operations.
To Next Page
