2100-900-01 Rev. D / September 2011 Return to Section Topics 5-7
Model 2100 6 1/2-Digit Resolution Digital Multimeter User’s Manual Section 5: Remote Interface Operations
[SENSe:]
FREQuency:APERture {0.01|0.1|1|MINimum|MAXimum}
FREQuency:APERture? [MINimum|MAXimum]
PERiod:APERture {0.01|0.1|1|MINimum|MAXimum}
PERiod:APERture? [MINimum|MAXimum]
[SENSe:]
DETector:BANDwidth {3|20|200|MINimum|MAXimum}
DETector:BANDwidth? [MINimum|MAXimum]
[SENSe:]
AVERage:TCONtrol {MOVing|REPeat}
AVERage:TCONtrol?
AVERage:COUNt {<value>|MINimum|MAXimum}
AVERage:COUNt? [MINimum|MAXimum]
AVERage:STATe {OFF| }
AVERage:STATe?
[SENSe:]
ZERO:AUTO {OFF|ONCE| }
ZERO:AUTO?
GAIN:AUTO {OFF|ONCE| }
GAIN:AUTO?
Other measurement configuration commands
[INPut:]
IMPedance:AUTO {OFF|ON}
IMPedance:AUTO?
ROUTe:TERMinals?
Math operation commands
There are eight math operations. Only one of them can be enabled at a time. They either store
data for later use or perform mathematical operations on the readings. Note that these eight math
operations are available to all measurement functions except continuity and diode testing.
The math operations use one or more internal registers. You can preset the values in some of the
registers by entering constants in some of the commands (e.g.,
), while others hold the results of the math operations (some commands are the result of a
calculation, e.g., ).
[CALCulate:]
FUNCtion {PERCent|AVERage|NULL|LIMit|MXB|DB|DBM}
FUNCtion?
STATe {OFF|ON}
STATe?
[CALCulate:]
PERCent:TARGet {<value>|MINimum|MAXimum}
PERCent:TARGet? [MINimum|MAXimum]
[CALCulate:]
AVERage:MINimum?
AVERage:MAXimum?
To Next Page
Loading...
Need help?
General
