B-18 Return to Section Topics 2100-900-01 Rev. D / September 2011
Appendix B: Remote Interface Reference Model 2100 6 1/2-Digit Resolution Digital Multimeter User’s Manual
TRIGger:DELay {<seconds>|MINimum|MAXimum}
Set a trigger delay time in seconds. The delay is the time between the trigger signal and each
sample that follows. Specify a delay time from 0 to 3,600 seconds.
TRIGger:DELay?
Query the trigger delay time.
TRIGger:DELay:AUTO {OFF|ON}
Disable or enable an automatic trigger delay. The delay is determined by function, range,
integration time, and AC filter settings. Specifying a delay time automatically turns off the
automatic trigger delay.
TRIGger:DELay:AUTO?
Query the automatic trigger delay mode. Returns "0" (OFF) or "1" (ON).
SAMPle:COUNt {<value>|MINimum|MAXimum}
Set the number of readings (samples) the multimeter takes per trigger. Select a number from 1 to
50,000 readings per trigger.
SAMPle:COUNt ? [MINimum|MAXimum]
Query the sample count.
TRIGger:COUNt {<value>|MINimum|MAXimum|INFinite}
Specify the number of triggers the multimeter will accept before returning to the "idle" state. Select
from 1 to 50,000 triggers. The INFinite parameter instructs the multimeter to take triggers
continuously. Trigger count is ignored while in local operation.
TRIGger:COUNt? [MINimum|MAXimum|INFinite]
Query the trigger count. Returns "9.90000000E+37" when you select the infinite trigger count.
The system-related commands
FETCh?
Transfer readings stored in memory by the INITiate command to output buffer, where you are able
to read them into your bus controller.
To Next Page
Loading...
Need help?
General
