6-4 Return to Section Topics 2100-900-01 Rev. D / September 2011
Section 6: Error Messages Model 2100 6 1/2-Digit Resolution Digital Multimeter User’s Manual
Self-test errors
Refer to the Self-test descriptions in Section 4.
531 Insufficient memory There is not enough memory to store the requested number of readings in
internal memory using the INITiate command. The product of the sample
count (SAMPle:COUNt) and the trigger count (TRIGger:COUNt) must
not exceed 512 readings.
532 Cannot achieve
requested resolution
The multimeter cannot achieve the requested measurement resolution.
You may have specified an invalid resolution in the
CONFigure or
MEASure command.
540 Cannot use overload as
math reference
The multimeter cannot store an overload reading (9.90000000E+37) as the
math reference for null or dB measurements. The math state is turned off
as a result of this condition.
550 Command not allowed in
local
The multimeter received a READ? command while in the local mode.
Table 6-1 (continued)
Execution error codes
Error code Description
To Next Page
Loading...
Need help?
General
