S530 Parametric Test Systems
Frequency Analysis Option Manual Section 3:
S530-923-01 Rev. A / January 2014 3-11
freq_detect_peaks
Purpose: This command returns frequencies in signal amplitude order (see next figure). You get to
choose the total number of peaks. If a given peak detected is not greater than the
minimum level (min_level), that peak will be dropped and the frequency will be
returned as zero. If the peak detected is a part of a single frequency spectrum, this peak
will be ignored. Each measured peak frequency will have a corresponding measured
signal level returned in the measured_signal_levels array.
Figure 7: Freq_detect peaks upper and lower bounds
To Next Page
Loading...
