KeLi D2002E - Page 21

www.kelichina.com Page 21 of 38
7.Set displayed
decimal
number
Press[0][1]
Press[Enter]
[Pont **]
[Pont 01]
Display original set decimal number
Set the decimal number to one. 00、01、02、03
is available. They are separately no decimal,
one decimal, two decimal and three decimal.
Press [Check] to skip this step, press [Weight]
back to the weighing state
Press [Enter] to finish the setting of displayed
decimal number.
8.Set PC
communication
baud rate
Press[0][1]
Press[Enter]
[bt **]
[bt 01]
Display original set baud rate and verify
mode. Perch is verify mode: 0 stands for no
verification, 1 stands for odd and 2 stands for
even; Lowness is baud rate: 0、1、2、3、4
separately stands for baud rate 9600、4800、
2400、1200、600.
Stands for baud rate 4800 and no verification;
Press [Enter] to finish the setting.
Press [Check] to skip this step.
9. Set
communication
agreement
Press [0][1]
[pt **]
[pt
01]
Display original set communication mode. 00
stands for the communication mode one, 01
stands for the communication mode three, 02
stands for the communication mode two; For
details please refer to the user’s manual page
9 and 10;
Set communication mode to mode three
10 Set strain
wave
coefficient
Press[3][2]
[Lb **]
[Lb 32]
Display original set strain wave coefficient
Set strain wave coefficient to 32, the first
number stands for strain wave range. 0、1、2、
3、4、5 available，separately stands for weaving
range 0kg、100kg、200kg、300kg、400kg、
500kg；the second number stands for strain
wave strength. 0、1、2、3、4、5 available. The
bigger the number is, the stronger the strain