version.Both functions can be used at the same time.KLS controller can support KTY84-150
and KTY84-130 thermistors.
3.2.4 Communication Port
A 4pin connector to RS232 port is provided to communicate with host computer for calibration and
configuration.
Figure 10: RS232 Interface on 4pin connector to RS232 converter
Figure 11：SM-4P connector for communication interface on KLS-H controller
3.3
Installation Check List
Before operating the vehicle, complete the following checkout procedure. Use buzzer code
as a reference as listed in Table 1.
Caution:
•
Put the vehicle up on blocks to get the drive wheels off the ground before beginning these
tests.
•
Do not allow anyone to stand directly in front of or behind the vehicle during the checkout.
•
Make sure the PWR switch and the brake is off
•
Use well-insulated tools.
To Next Page
Loading...
Need help?
General
