Kemppi FastMig X 350 User Manual

EN
Info Shows following information about the selected device.
Device name:
DevSW: Unit software version.
SysSW: System software version (base software version).
BootSW: Boot software version.
SW Item: Software item number (IFS code).
Serial: Device serial number.
Prog: Programmer name
Date: Programming time and date.
Restore Settings User 1 (one of ten users) Channel:
Selected user can restore to his backup memory channels one by one.
Other users’ memory channels remain untouched.
Setup settings remain untouched.
User 1 (one of ten users) All Channels:
Selected user can restore all of his backup memory channels (0-9) at one time.
Other users’ memory channels remain untouched.
Setup settings remain untouched.
Restore To Factory:
All channels (of all users) are removed.
All users’ backup channels are removed.
All setup settings are set to defaults.
When MMA/CC/CV Mode is selected, the Restore Settings options are:
MMA/CC/CV Channel
MMA All channels
Restore To Factory
Licence Menu Licence Code allows you to enter the licence code:
- Up and down arrows are used to select the code number position.
- Pulse encoder is used to select the code number (0–255) to be entered.
- Soft key button on the right is used to activate the licence number (after all numbers have
been entered). In case the code was wrong the earlier view will be displayed.
Licence Timers allows you to check the remaining time of the time-based Wise features.
WeldData Delay 1…60 s Step: 1
Factory Setting is 20 s.
Denes how long time the Weld Data is
displayed after welding ends.
Weld Data display is also turned o
when pulse encoder is turned or any
button is pressed.
Display Delay 1…20 s Step: 1
Factory setting is 10
Denes how long time the information
is displayed (e.g. “Setting Saved” text).
This is not always the exact time.
Pre Gas Time 0.0…9.9 s, CURVE. Step: 0.1
Factory settings is CURVE
CURVE: Pre Gas time is read from the
Welding program.
0.0 – 9.9s: User Pre Gas time setting.
Post Gas Time 0.0…9.9 s, CURVE. Step: 0.1
Factory settings is CURVE
CURVE: Pre Gas time is read from the
Welding program.
0.0 – 9.9s: User Post Gas time setting.
FastMig X 450
18

Kemppi FastMig X 350 Specifications

General

Brand	Kemppi
Model	FastMig X 350
Category	Welding System
Language	English