EN
CC PROCESS
Current 10…450 A Welding current
CurrentMax 10…450 A Set the limit for maximum current value
CurrentMin 10…450 A Set the limit for minimum current value
Dynamics -9…+9 Factory setting
is 0
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher
the value the rougher the arc is.
StartPower -9…+9 Factory setting
is 0
Adjusts arc ignition
CV PROCESS
Voltage 10…50 V Welding voltage
VoltageMax 10…50 V Set the limit for maximum voltage value
VoltageMin 10…50 V Set the limit for minimum voltage value
Dynamics -9…+9 Factory setting
is 0
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher
the value the rougher the arc is.
StartPower -9…+9 Factory setting
is 0
Adjusts arc ignition
4.4 Welding functions
WISEROOT+ AND OTHER PROCESSES
2T/4T 2T, 4T,
MATCHLOG, USER
Factory setting is USER (user
chooses the switching logic)
Sets switching logic
HotStart ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
HotStartLevel -50…+100 % Step: 1
Factory setting 40%
Hot 2T Time 0…9.9 s Step: 0.1
Factory setting is 1.2 s
CraterFill ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
CraterStart 10…250 % Factory setting is 100% Sets the level of the curve where the
crater lling will start
CraterFillEnd 10…250 %, not
higher than start
Step: 1
Factory setting is 30%
Sets the level of the curve where the
crater lling will end.
CraterTime 0.0…10.0 s Step: 0.1.
Factory setting is 1.0 s
Sets slope time for crate lling
Crater 4T Timer On, OFF Factory setting is OFF ON: if 4T is selected, crater lling will
last at least time that has been adjusted
by CraterTime or as long as trigger is
pressed.
OFF: if 4T is selected, crater lling will
last as long as trigger is pressed.
FastMig X 450
16
To Next Page
Loading...
Need help?
General
