Kemppi Minarc 110 - Main Components of the Unit; Connecting to Power Supply Mains; Filler Materials and Equipment

© COPYRIGHT KEMPPI OY
Minarc/0244 – 5
2.4. MAIN COMPONENTS OF THE UNIT
Connect welding cable and earth cable to their connections on the power source. Mains
cable and wall plug are already installed.
Parts of the unit
A Body of machine
B Main power switch and signal light
C Selector switch for welding
process
D Welding current regulator
E Signal light for overheating
F Electrode holder and welding
cable
G Earth cable and clamp
H Mains cable
2.5. CONNECTING TO POWER SUPPLY MAINS
The unit has a mains cable and a wall plug. You can fi nd fuse and cable sizes in the end
of these instructions on Technical information table.
2.6. FILLER MATERIALS AND EQUIPMENT
See also 2.4. Main components of the unit. You can use all electrodes intended for
welding with DC. Suitable electrode sizes for the unit are listed in the end of these
instructions in chapter Technical information.
1. Use welding specifi cations given on electrode package.
2. Check that you have selected the correct welding process, before starting
to weld.
3. Check that welding cable and earth cable connections are tight. If a connec-
tion is slack, it will result in voltage drop, that will cause the connection
to heat.
4. Mount the electrode fi rmly in holder.
-
+
A
H
B
C
D
E
G
F