To Next PageTo Next Page
Need help?Do you have a question about the Kemppi MinarcMig Evo 200 and is the answer not in the manual?
General| Input Voltage | 230 V |
|---|---|
| Wire Feed Speed | 1 - 15 m/min |
| Weight | 13 kg |
| Welding Processes | MIG/MAG, MMA |
| Rated Input Current | 16 A |
| Wire Diameter (MIG/MAG) | 0.6 - 1.0 mm |
| Protection Class | IP23S |
| Duty Cycle (MIG/MAG at 200 A) | 35% |
| Electrode Diameter (MMA) | 1.5 - 4.0 mm |
Connect the device to the power source and turn it on.
Connect the shielding gas supply and adjust the gas flow rate.
Load the wire spool, secure it, and adjust the spool brake force.
Replace the 5kg spool holder with the 1kg holder and secure the spool.
Insert the filler wire and set the feed roll pressure based on wire type.
