What to do if over-heating indicator light switches on in Kemppi Welding System?
If the over-heating indicator light is on, it could be due to several reasons. First, ensure that cooling air can flow without obstructions. Second, if the machine’s volume-capacity ratio has been exceeded, wait for the indicator light to switch off. Finally, low or high supply voltage might also be the cause.
What to do if the wire does not move or wire feed entangles in Kemppi MinarcMig Adaptive 150?
If the wire isn't moving or the wire feed entangles, make sure the feed rolls aren't too tight or too loose. Also, check if the feed roll groove is worn. Ensure that the wire conduit isn't blocked and that there are no spatters on the conduit tip, and the hole isn't cramped or worn loose.
Why Kemppi MinarcMig Adaptive 150 welds badly?
Welding performance can be impacted by several factors. Ensure the welding power control and arc length trimming settings are properly adjusted. Verify that the earthing clamp is securely attached to a clean fixing point and that the cable and connections are undamaged. Also, check the shielding gas flow from the welding gun tip. Note that uneven, low, or high supply voltage may affect welding.
Why main switch indicator light does not switch on in Kemppi MinarcMig Adaptive 150 Welding System?
If the main switch indicator light doesn't turn on, the machine might not be receiving supply voltage. Check the supply voltage fuses, supply voltage cable, and plug.
General| Input Voltage | 230 V |
|---|---|
| Welding Process | MIG/MAG |
| Input Current | 16 A |
| Output Current | 150 A |
| Duty Cycle at 150 A | 60% |
| Wire Diameter | 0.6 - 1.0 mm |
| Input Frequency | 50/60 Hz |
| Power Factor | 0.93 |
| Efficiency | 85% |
| Protection Class | IP23 |
| Cooling Method | Air-cooled |
To Next Page