MinarcMig™ Adaptive 150
© Kemppi Oy 0550 5
EN
NOTE! Fire caused by sparks may brake out even after several hours!
CAUTION! Welding in inflammable and explosive sites is strictly
forbidden!
2.4. SUPPLY VOLTAGE
• Do not take the welding machine inside a workpiece, for example in to a
container or a car.
• Do not place the welding machine on a wet surface.
• Change faulty cables immediately for they are life-threatening and may
cause a fire.
• Ensure that cables are not squeezed or in contact with sharp edges or a hot
workpiece.
2.5. WELDING CIRCUIT
• Insulate yourself from the welding circuit by using dry and undamaged
protective clothing.
• Do not work on a wet surface.
• Do not use damaged welding cables.
• Do not place the welding gun or earthing clamp on the welding machine or
other electrical device.
2.6. WELDING FUMES
Make sure ventilation is sufficient. Take special precautions when welding
metals containing lead, cadmium, zinc, mercury or beryllium.
Supply of sufficient clean air can also be ensured with the use of a fresh air
mask.
To Next Page
Loading...
