Kendro HERAcell 150 - English; Default Chapter; Table of Contents

CO
2
Incubator HERAcell
®
150 Operating Instructions
3
Contens
1. General notes ........................................................................................ 6
1.1 General safety instructions .......................................................... 7
1.2 Warranty ..................................................................................... 7
1.3 Explanation of symbols ............................................................... 8
1.3.1 Symbols used in the operating instructions:.............................. 8
1.3.2 Symbols used in the quick referenc: ......................................... 9
1.3.3 Symbols on the device: .......................................................... 10
1.4 Intended purpose of the device ..................................................11
1.4.1 Correct use .............................................................................11
1.4.2 Incorrect use: ..........................................................................11
1.5 Standards and directives ........................................................... 12
1.6 Safety notes on gases ............................................................... 12
2.Delivery .................................................................................................... 15
2.1 Packaging ................................................................................. 15
2.2 Components standard equipment .............................................. 15
2.3 Acceptance inspection .............................................................. 16
3. Installation of the device ..................................................................... 17
3.1 Ambient conditions .................................................................... 17
3.2 Room ventilation ....................................................................... 17
3.3 Space requirements .................................................................. 18
3.4 Transport ................................................................................... 18
3.5 Stacking .................................................................................... 19
3.6 Retrofitting/Modifications ........................................................... 19
3.7 Tray........................................................................................... 19
4. Description of the device .................................................................... 20
4.1 Front view ................................................................................. 20
4.2 Rear view .................................................................................. 21
4.3 Safety devices........................................................................... 22
4.4 Work space atmosphere ............................................................ 22
4.5 ContraCon decontamination routine .......................................... 23
4.6 Sensor system .......................................................................... 24
4.7 Door switch ............................................................................... 24
4.8 Switchbox with supply interface ................................................. 25
4.9 Work space components ........................................................... 26
5. Start-up ................................................................................................ 29
5.1 Preparing the work space .......................................................... 29
5.2 Installing the shelf system ......................................................... 29
5.3 Gas connection ......................................................................... 31
5.3.1 Installing gas pressure hoses ................................................. 32
5.3.2 Installing devices without gas guard ....................................... 32
5.3.3 Connecting devices with gas guard ........................................ 33
5.4 Power supply connection........................................................... 35
5.5 RS 232 interface connection ..................................................... 36
5.6 Connecting the alarm contact .................................................... 38
6. Handling and control .......................................................................... 40
6.1 Power switch ............................................................................. 40
6.2 Operating panel ......................................................................... 40
6.3 Control self-test ......................................................................... 41