APPLIQUE Use disc #1A
Baste cutout applique to fabric. Set stitch width 2 to
4. Set stitch length at the red marking. Zigzag stitch
around applique completely covering the raw edge.
SEWING ON LACE Use disc #1A
Set stitch width to 1. Set stitch length to 1 or 2. Place
fabric under the presser foot and place lace on top of
fabric overlapping edge by ¼ inch. Start sewing with
needle at the left stitch. Position fabric and lace so
that needle goes into left edge of lace. To sew two
pieces together to make a continuous pattern, use the
same method.
STRAIGHT OR THREE – CORNERED TEAR
Stitch width 4
Stitch length at red mark
Pattern disc #4A
Position tear under needle and stitch along the
straight tear catching sides of material. When
mending a three cornered tear, stitch from each end
to center.
22
To Next Page
Loading...
Need help?
General
