1. SETTING THE DOUBLE NEEDLE
DOUBLE NEEDLE
Raise the needle bar to its highest position and loosen
needle clamp screw. Hold double needle assembly with flat
side away from you. Slip the needle as far as it will go into
needle clamp, and tighten the screw.
2. THREADING THE DOUBLE NEEDLE
Place a spool of thread on each spool pin. Draw each
threads through upper thread guides. Continue threading
the machine as you would for single needle sewing. Draw
one thread through each needle from front to back and pull
several inches of thread through. Thread bobbin and pick up
bobbin thread as for single needle sewing.
3. THREAD SELECTION
Use mercerized sewing thread size #50 and finer. Machine
embroidery thread is recommended for both upper and
lower threading.
24
To Next Page
Loading...
Need help?
General
