Kenmore 158.1813 - Installing Machine

INSTALLING
MACHINE
1 . Loosen the two
hinge
screws under
holes in the rear edge of the ma-
chine bed .
5 . Plug machine cord into any 110-
120 volt wall outlet . Turn on power
by
pushing light and power switch .
2 . Raise hinge pins in the cabinet
cutout . Slip machine head onto
pins .
3 . Tighten hinge screws securely
.
4 . Push the plug onto three-prong
connector under the bed plate .
Lower machine head to front
cabinet flap .
6 . Spool
pins are packed in accessory
box . Screw thread spool pins in
place . Position nylon discs as
shown in illustration . Wipe ma-
chine
of
excess oil used in shipping .