OTHER THINGS TO KNOW
SECTION 4
19
4A. HOW TO “FINE-TUNE” YOUR SOFTENER
c. Press the RECHARGE DAY button ¢ and
SUnday begins to flash.
---- If you want regenerations on Sunday (from
regeneration table), press the SET/CLEAR but-
ton £ to display ON.
----IfyoudonotwantSundayregenerations,press
SET/CLEAR button £ to display OFF.
d. Press the RECHARGE DAY button ¢ again
todisplayaflashingMOndayandON(facto-
ry set recharge). As youdid in stepc, usethe
SET/CLEARbutton£tochangethedisplay
from ON to OFF, or from OFF to ON.
e. PressRECHARGEDAYbutton¢todisplay
a flashing TUesday, WEdnesday, etc., each
timeusingtheSET/CLEAR button£todis-
play either ON or OFF as needed.
After recharge is either set or cancelled for
SAturday, press the PRESENT TIME AND
DAYbutton¡onceagaintoreturnthe pres-
ent time and day display.
2. SET THE FILL CYCLE MINUTES
a. Press and hold the RECHARGE TIME button
© until FILL shows in the display, then re-
lease button ©. After a few seconds, the fill
cycle minutes (factory setting¼8) will flash.
b. Press the SET/CLEAR button £ to set the
minutes of fill cycle needed, as shown in the
regeneration table.
NOTE:
You may get hard water between regenerations
ifyousetthetimerforfewerfillminutesthanthe
Regeneration Table shows you to set. A higher
setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move
thedisplayahead1minuteatatime.Or,holdthe
SET/CLEARbuttontomovethedisplayahead2
minutes each second. THE DISPLAY BEGINS
OVER AT 0 AFTER PASSING 59.
c. Press PRESENT TIME AND DAY button ¡
to return the present time and day display.
TO SET THE PRESENT TIME OF DAY, AND
DAY OF WEEK, SEE PAGE 6.
IF YOU NEED HELP TO PROGRAM THE TIMER, CALL TOLL FREE,
NUMBER 1-800- 426-9345.
To Next Page
Loading...
