Kenmore CROSSOVER ULTRA

Questions and Answers

X
xmitchellAug 2, 2025
Why won't my Kenmore CROSSOVER ULTRA run?
- V
  vburgessAug 2, 2025
  If your Kenmore Vacuum Cleaner won’t run, first ensure it is plugged into the wall outlet. If it is plugged in, check the circuit breaker or fuse and reset the breaker or replace the fuse if necessary. Allow 3-5 minutes to cool down. If the outlet is defective, have it serviced by a qualified appliance technician.
R
Rose HinesAug 6, 2025
How to improve dirt pick-up on my Kenmore Vacuum Cleaner?
- T
  tmccoyAug 6, 2025
  If your Kenmore Vacuum Cleaner isn't picking up dirt well, start by emptying the dust cup and cleaning the filters. Check for and remove any clogs in the nozzle, hose, or wand. Replace the belt if it is worn or broken, and replace the hose if there is a hole in it. Ensure the hose is fully inserted and check if suction control is activated.
J
Jacob HallAug 11, 2025
Why is the agitator not turning on my Kenmore Vacuum Cleaner?
- B
  bennettjerryAug 12, 2025
  If the agitator on your Kenmore Vacuum Cleaner isn't turning, make sure the handle is in the correct position and press the AGITATOR RESET button. Allow 3-5 minutes to cool down. Also, check that the nozzle switch is not in the BARE FLOOR position; if it is, press the nozzle switch to change the setting.
E
Edward HarringtonAug 17, 2025
What to do if my Kenmore CROSSOVER ULTRA Vacuum Cleaner Pet HandiMate[®] has poor dirt pick-up?
- G
  Gary McguireAug 17, 2025
  If the Pet HandiMate[®] on your Kenmore Vacuum Cleaner isn't picking up dirt well, start by cleaning the agitator to remove any carpet pile entangled around it. If the belt is worn or broken, the Pet HandiMate[®] is not a serviceable item and should be replaced. Also, check vacuum cleaner troubleshooting tips. Ensure that the suction control is closed. If there is a hole in the vacuum hose, replace it.
H
Heather GardnerAug 22, 2025
How to fix a constant blue light on the dirt sensor of my Kenmore Vacuum Cleaner?
- D
  David MontesAug 22, 2025
  If the dirt sensor on your Kenmore Vacuum Cleaner has a constant blue light, check the air passages for clogs and clean the lenses.
E
Eric PerezAug 27, 2025
What to do if the Pet HandiMate[®] on my Kenmore CROSSOVER ULTRA will not run?
- H
  Haley ClarkAug 27, 2025
  If the Pet HandiMate[®] on your Kenmore Vacuum Cleaner will not run when attached, clean the agitator to remove any carpet pile entangled around it. If the belt is worn or broken, the Pet HandiMate[®] is not a serviceable item and should be replaced.