KENT Klenzor 16 MPH - Introduction and Initial Setup; Parts and Service Information; Machine Nameplate Details; Uncrating and Damage Inspection

04-12
1
Klenzor
™
16, 18 MPH
FORM NO. 56042453
TABLE OF CONTENTS
DESCRIPTION PAGE
Base System ........................................................................................... 2-3
Brush System .......................................................................................... 4-5
Decal System .......................................................................................... 6-7
Handle System 16 ................................................................................... 8-9
Handle System 18 ............................................................................... 10-11
Recovery System ................................................................................ 12-13
Solution Pump System ........................................................................ 14-15
Solution Tank Assembly ......................................................................16-17
Wiring Diagram ...................................................................................18-19
Hard Floor Tool Kit ..............................................................................20-21
Accessories .............................................................................................. 22
WHEN ORDERING PARTS
* Use the 8 digit numbers from the “Ref. No.” columns in this parts list.
* Specify the model and serial number of the machine.
* Use the space below to record the model and serial number for future reference.
Model Serial No.