KENT C-4 - User Manual

TABLE OF CONTENTS
Contact Information:

KENT C-4 Specifications

General

Category	Floor Machine
Model	KENT C-4
Brush Motor	1.5 HP
Frequency	50 Hz
Brush Size	17 in
Solution Tank	20 L
Recovery Tank	20 L

Summary

Important Safety Instructions

Safety Guidelines

Warnings

Grounding Instructions

Carpet Cleaning Instruction

Upholstery Cleaning

Machine Operation and Troubleshooting

Loss of Electrical Power

Check power connections, switches, and circuit breakers if the machine has no power.

Loss of Vacuum; Little or No Suction

Lack of Water Pressure

No Brush Movement

Repair Manual

Removing the Vacuum and Brush Assemblies

Step-by-step guide to detach vacuum and brush components from the unit.

Replacing the Vacuum Motor (18007)

Instructions for removing and installing a new or rebuilt vacuum motor.

Replacing the Brush Motor (18005)

Procedures for replacing the brush motor assembly on the machine.

Replacing the Pump Motor (18006)

Steps to remove and install a new pump motor.

Removing the Brush Assembly (18210)

Guide for detaching the brush assembly for maintenance or replacement.

Rebuilding the Brush Assembly (18210)

Instructions for cleaning, inspecting, and reassembling the brush assembly.

Replacing the Front Nozzle Clip (10031)

Replacing the Rear Nozzle Clip (10002)

Replacing the Trigger Switch (18207)

Replacing Rocker Switches and Assemblies