CARPET CLEANING INSTRUCTIONS
SECTION A: PREPARING CARPET
1. Vacuum carpet with your vacuum cleaner, NOT the C-4 extractor. 2. Pre-treat spotted and heavily soiled areas of carpet.
SECTION B: PREPARING THE MACHINE
1. Pull Bucket Handle outward, lift the Lid and remove Bucket. 2. Fill Bucket with hot tap water to the 2.5 or 3.5 gallon fill line. Add 2
oz. (60 mL) of cleaner per gallon of water. 3. IMPORTANT: Pour Bucket contents into the Solution Tank.
4. Return Bucket, Lid and
Handle.
B1 B2 B3 B4
WARNING!: Do not use bleach or dye in this machine. User will be liable for all damage done to machine, carpets and upholstery.
SECTION C: CLEANING CARPET
1. Adjust Handle to desired height using Black “T” Handle. 2. Make sure all Switches are off. Plug machine in. 3. Tilt the machine
back and move to start position. 4. Turn ON the Suction Switch. IMPORTANT: Hand Tool Switch must be OFF during carpet
cleaning! 5. Squeeze Spray/Brush Trigger as you pull the machine backwards.
C1 C2 C3 C4
TIP: Strokes should be at a slow, steady pace, five feet long with a two-inch overlap. Release Spray/Brush Trigger four inches before
end of stroke. Heavily soiled areas may require a second cleaning at a right angle to the first cleaning.
IMPORTANT: After moving furniture on damp carpet, place foil under the legs IMMEDIATELY to avoid carpet staining.
C6 C7
IMPORTANT: If foam is in the
left Lid Tube, add 2 ounces (60
mL) of Anti-Foam to the
Bucket. Or, empty Bucket
contents and replace without
refilling the machine.
6. As you clean, dirty solution
passes through the right Lid
Tube. When extraction
ceases, machine is empty. 7.
Turn OFF Switches. Discard
dirty water. Rinse Bucket.
Refill according to instructions.
3
To Next Page
Loading...
Need help?
General
