Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2 Enter Speaker Setting mode
Press the [Q] button.
3 Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
Speaker Setting
Adjustment Item Display Range
Bass level "Bas" –8 — +8
Middle level "Mid" –8 — +8
Treble level "Tre" –8 — +8
Balance "Bal" Left 15 — Right 15
Fader "Fad" Rear 15 — Front 15
Volume offset "V-OFF" –8 — ±0
Volume offset: Each source's volume can be set as a difference
from the basic volume.
5 Exit Audio Control mode
Press the [AUD] button.
— 11 —
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
4 Exit Speaker Setting mode
Press the [Q] button.
KDC-MPV619_H_U.S r1 03.3.18 9:35 AM Page 11
To Next Page
Loading...
Need help?
General
