What to do if my Kenwood Car Navigation system plays the wrong disc?
If your Kenwood Car Navigation system plays the wrong disc, the disc may be dirty. Clean the disc. Alternatively, the disc may be severely scratched, so try another disc instead.
Why is radio reception poor on my Kenwood Car Navigation system?
If the radio reception is poor on your Kenwood Car Navigation system, make sure the car antenna is fully extended. Also, check that the antenna control wire is correctly connected.
What to do if I cannot select the output destination of the subsource in the dual zone on my Kenwood DNN9150BT?
If you can't select the output destination of the subsource in the dual zone on your Kenwood Car Navigation system, it might be because the dual zone function is disabled. To solve this, set the dual zone function to on.
Why can't I adjust the volume of the rear speakers on my Kenwood DNN9150BT Car Navigation system?
If you cannot adjust the volume of the rear speakers on your Kenwood Car Navigation system, it may be because the dual zone function is disabled. Set the dual zone function to on.
What to do if there is no output from the subwoofer on Kenwood DNN9150BT Car Navigation system?
If there is no output from the subwoofer on your Kenwood Car Navigation system, the subwoofer may not be set to 'on'. To fix this, set the subwoofer to 'on'.
Why can't my Kenwood DNN9150BT Car Navigation system play audio files stored on a disc?
If your Kenwood Car Navigation system cannot play audio files stored on a disc, it might be because “CD Read” is set to “2”. Set “CD Read” to “1”.
Why can't I set up the subwoofer phase on my Kenwood DNN9150BT?
If you cannot set up the subwoofer phase on your Kenwood Car Navigation system, it is because the subwoofer is not set to on. Set the subwoofer to on.
Why is there no output from the subwoofer on my Kenwood Car Navigation system?
If there is no output from the subwoofer on your Kenwood Car Navigation system, it is because the subwoofer is not set to on. Set the subwoofer to on.
What does 'Mecha Error' mean on my Kenwood Car Navigation system and how to fix it?
A 'Mecha Error' on your Kenwood Car Navigation system indicates that the disc player is malfunctioning. Eject the disc and try inserting it again. If the error persists, contact your Kenwood dealer.
What to do if I get an Error Message Protect on my Kenwood Car Navigation system?
The 'Error Message Protect' on your Kenwood Car Navigation system indicates that the protective circuit has been activated because a speaker cord has shorted or is in contact with the car chassis. To resolve this, wire or insulate the speaker cord as appropriate, and then press the Reset button.
General| Brand | Kenwood |
|---|---|
| Model | DNN9150BT |
| Category | Car Navigation system |
| Language | English |
To Next Page
