Kenwood DSP-100 Manual

DIP Switch Setting
| ‘Switch No. Position (ON/OFF) Description
Turns the LPF (Low Pass Filter) on or off.
1 LPF In/Out This filter determines the high-cut
frequency for transmit and receive.
6 FSK/PSK Determines the type of waveform
generated in the FSK mode.
Allows a double sideband, suppressed
3 ‘SSB/DSB carrier to be generated during SSB
operation
when
tumed
Off
A A 3 Controls, the carriers suppression notch
4 Carrier Suppression notch filter In/Out filter during transmit operations.
Selects the desired CW waveform
CW waveform Rise-Decay time select | characteristics.
FAST/SLOW ‘ON_ FAST: 2 mS, SLOW: 4 mS
OFF FAST: 6 mS, SLOW: 8 mS
FILTER switch transmit/receive selection, The LPF/HPF switches on the front panel
|| are controlled by the FILTER switch during
Switch | Switch transmit or receive. It is also possible to fix
No.6 | No.7 the filter of transmit or receive at the 100
Hz Low-cut and 3100 Hz High-cut
6.7 ON | ON [Front switches contro! RX and TX || bandwidth,
ON
|
OFF
Fixed
during
RX.
OFF
|
ON
Fixed
during
TX.
|| oF | OFF | Controlled by transceiver.
[Controis the receiver HPF that determines
8 Receive HPF control | the low frequency cutoff point.
7 Controls the transmit HPF that determines
9 ‘Transmit HPF contro! | te ow tea Ai
10 Remote Control | Usually yj tunad í on. Allows DSP-100 to
Notes j J
4. The functions of DIP switches 1, 8, and 9 have priority over the operation of DIP switches 6 and 7.
2. If there is no compatible transceiver that can control the functions of DIP switches 6 and 7 the filter
passband will be fixed at 200 Hz and 2750 Hz.
3.
The
occupied
frequency
band
during
transmit
is
increased
when
DIP
switch
1
is
off.
Use
of
an
extemal
audio equalizer, etc, is recommended if DIP switch 1 is off.
4. The low-frequency response of the transmitter is improved when DIP switches 4 and 9 are off. This has the
disadvantage
of
reducing
the
carrier
suppression
ratio
since
the
carrier
suppression
notch
filter
is
off.
We
therefore recommend that you leave DIP switches 4 and 9 on.
5. The LPF FILTER switch is not active when the speech processor of the transceiver is on.

Kenwood DSP-100 Specifications

General

Brand	Kenwood
Model	DSP-100
Category	Recording Equipment
Language	English