Why is there no audio from USB audio player connected to Kenwood K-501USB?
If you're not getting audio from a USB audio player connected to your Kenwood Stereo System, verify that the USB cable is properly connected. Also, check that the USB audio player is switched ON.
How to fix time display stopped and blinking on Kenwood Stereo System?
If the time display on your Kenwood Stereo System is stopped and blinking, adjust the correct time by following the instructions in the “Adjusting the Time of Day” section.
How to resolve CD sound skipping on Kenwood K-501USB Stereo System?
If the CD sound is skipping on your Kenwood Stereo System, try cleaning the disc as explained in the “Care and storage of CD” section.
Why Kenwood K-501USB Stereo System loaded CD cannot be played back?
If a CD isn't playing on your Kenwood Stereo System, ensure that the CD is placed correctly with the label side facing up. If it still doesn't play, clean the disc as described in the 'Care and storage of CD' section. If condensation is present, follow the instructions in 'Be careful against condensation' to evaporate it.
Why is there no audio from one speaker on my Kenwood K-501USB Stereo System?
If you're experiencing audio from only one speaker on your Kenwood Stereo System, check that the speaker cables are properly connected, referring to the connections section in the manual. Also, adjust the balance settings to ensure sound is distributed evenly between the speakers.
What to do if there is no audio from headphones with Kenwood K-501USB Stereo System?
If you're not getting any sound through your headphones on your Kenwood Stereo System, start by checking that the headphone plug is fully and correctly inserted. If it is, increase the volume level to a suitable listening level.
How to fix no audio output on Kenwood K-501USB?
If there is no audio output from your Kenwood Stereo System, ensure the cables are properly connected as described in the connections section of the manual. Also, make sure the volume is at an audible level and that muting is off. If you're using headphones, try unplugging them.
How to tune radio stations on Kenwood Stereo System?
To tune radio stations on your Kenwood Stereo System, first connect the antenna(s). Then, select the correct broadcasting band and tune into the frequency of the station you want to listen to.
What does it mean when the standby/timer indicator blinks in amber on Kenwood K-501USB?
General| USB Playback | Yes |
|---|---|
| Power Output | 50 W |
| Bluetooth | No |
| CD Player | Yes |
| Speakers Included | Yes |
| Remote Control | Yes |
| RMS output power | 25 W |
| Playback media | CD |
To Next Page
