Need help?Do you have a question about the Kenwood KAC-818 and is the answer not in the manual?
Audio Output| max power output (2 Ω) | 400 W ×1 |
|---|---|
| rated power output (4 Ω) | 200 W ×1 (DIN45324, +B=14.4V) |
| rated power output (2 Ω) | 300 W ×1 (100 Hz, 0.8 % THD) |
| frequency response (+0, –1 dB) | 5 Hz ~ 200 Hz |
| total harmonic distortion (rated power) | 0.01 % (100 Hz) |
| sensitivity (rated output) (MAX) | 0.2 V |
| sensitivity (rated output) (MIN) | 5.0 V |
| signal to noise ratio | 100 dB |
| input impedance | 10 kΩ |
| damping factor | More than 9900 (at ∑ connect) |
| low pass filter frequency (24 dB/oct.) | 50 ~ 200 Hz (variable) |
| infrasonic filter frequency (24 dB/oct.) | 15 / 25 Hz |
Power| operating voltage | 14.4 V (11 ~ 16 V allowable) |
|---|---|
| current consumption (4 Ω, 14.4 V, 10% THD) | 28 A |
Weight and Dimensions| dimensions (W ×H ×D) | 290 ×56 ×230 mm |
|---|---|
| weight | 3.7 kg |
Precautions to prevent injury or fire during installation and operation.
Precautions to prevent damage to the machine during installation and use.
Notes regarding installation problems and unit operation.
Critical cautions and advice for performing the installation procedure correctly.
Cautions regarding safe and effective installation locations for the unit.
Details on battery, ground, power control, and input/output terminals.
Explanation of SIGMA SERVO, Infrasonic, Low Pass Filter, and Input Sensitivity controls.
Description of the power indicator light and its status.
Situations that trigger the unit's protection function, causing the power indicator to go off.
Instructions and cautions for connecting the unit via RCA cables.
Instructions and cautions for connecting the unit using speaker level inputs.
Important warnings and guidelines for wiring to prevent fire and ensure proper connection.
Guidance on connecting power control, supply, and ground wires to the terminals.
Explanation of the sigma servo connection's role in reducing distortion.
Diagrams and cautions for basic, series, and parallel sigma servo connections.
Troubleshooting steps for when there is no sound or sound from only one side.
Guidance on adjusting input sensitivity for correct output levels.
Troubleshooting distorted sound, including cable polarity and switch settings.
To Next Page
