Need help?Do you have a question about the Kenwood KAC-8403 and is the answer not in the manual?
Key safety measures to prevent injury, fire, and equipment damage during operation.
Details on FCC regulations and compliance for radio frequency energy.
Guidelines for responsible recycling and disposal of electrical equipment.
Important notes on unit care, battery usage, protection modes, wiring, and speaker compatibility.
Step-by-step instructions for installing the amplifier unit and its components.
Critical warnings regarding installation locations, heat dissipation, and vehicle safety.
Details on connecting RCA cables or speaker level inputs to the amplifier.
Guidance on connecting power supply, ground, control wires, and speaker outputs.
Detailed explanation of each control knob, switch, and terminal on the amplifier's panel.
How to configure the amplifier's operating modes, filters, and sensitivity settings.
Visual guides for setting up 4-channel, 2-channel, and subwoofer systems.
Explanation of the Tri-mode setup using coils and capacitors for frequency division.
Solutions for common problems like no sound, low output, or distorted audio.
Detailed technical data including power output, frequency response, and dimensions.
General| Channels | 4 |
|---|---|
| Max Power Output | 800W |
| RMS Power Output (2 Ohms) | 75W x 4 |
| Bridged RMS Power (4 Ohms) | 150W x 2 |
| Frequency Response | 10Hz - 50kHz |
| THD at Rated Power | 0.08% |
| Input Voltage | 14.4V |
| Input Sensitivity | 0.2V - 5V |
| Crossover | High-pass/Low-pass |
To Next Page
