Need help?Do you have a question about the Kenwood KAC-9152D and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| RMS Power at 2 Ohms | 900 W |
| Minimum Impedance Unbridged | 1 Ohm |
| THD at Rated RMS Power | 0.5% |
| Signal to Noise Ratio | 100 dB |
| Bass Boost | 0 - 18 dB |
| Bass/EQ Frequency | 40 Hz |
| Input Sensitivity | 0.2 V - 6 V |
| Low Pass Filter | Yes |
| Bass Boost Frequency | 40 Hz |
| Fuse Rating | 40 A |
Safety warnings regarding fire prevention, injury, and unit heat.
Precautions for cleaning, preventing battery drain, and understanding protection functions.
Proper wiring methods and speaker selection for safe operation.
Step-by-step instructions for installing the amplifier unit.
Important warnings about installation locations and methods.
How to connect RCA cables and speaker level inputs.
Detailed steps for connecting power, ground, and speaker wires.
Specifics for connecting the remote cable to the unit.
Information on fuses, battery, ground, and power control terminals.
Details on speaker output, speaker level input, and line input/output terminals.
Explanation of LPF Frequency, Input Sensitivity, and Phase controls.
Controls for adjusting bass boost level and frequency.
How to set up and connect the dual mono drive system for high output.
Important safety precautions for the dual mono drive configuration.
Resolving problems with no sound or incorrect output levels.
Troubleshooting distorted sound and non-functional remote controllers.
To Next Page
