Need help?Do you have a question about the Kenwood KAC-923 and is the answer not in the manual?
Audio Specifications| Max Power Output (4 ohm) | 220 W + 220 W |
|---|---|
| Rated Power Output at 12 V (4 ohm) Normal | 100 W + 100 W |
| Rated Power Output at 12 V (4 ohm) Bridged | 270 W |
| Rated Power Output (2 ohm) Normal | 135 W + 135 W |
| Frequency Response | 2 Hz ~ 45 kHz |
| Sensitivity (rated output) | 0.15 V |
| Signal to Noise Ratio | 105 dB |
| Input Impedance | 10 kΩ |
| Damping Factor (100 Hz) | More than 200 |
| Low Pass Filter Frequency | 30 ~ 200 Hz (variable) |
General Specifications| Operating Voltage | 12.0 V (11~16 V allowable) |
|---|---|
| Current Consumption (MAX.) | 30 A |
| Dimensions (W x H x D) | 273 x 56 x 250 mm |
| Weight | 4.1 kg |
Audio Specifications| Max Power Output (4 ohm) Normal | 200 W + 200 W |
|---|---|
| Max Power Output (4 ohm) Bridged | 480 W |
| Rated Power Output (4 ohm) Normal | 100 W + 100 W |
| Rated Power Output (4 ohm) Bridged | 250 W |
| Rated Power Output (2 ohm) Normal | 125 W + 125 W |
| Frequency Response | 2 Hz ~ 45 kHz |
| Sensitivity (rated output) | 0.15 V |
| Signal to Noise Ratio | 105 dB |
| Input Impedance | 10 kΩ |
| Damping Factor (100 Hz) | More than 200 |
| Low Pass Filter Frequency | 30 ~ 200 Hz (variable) |
General Specifications| Operating Voltage | 14.4 V (11~16 V allowable) |
|---|---|
| Current Consumption (MAX.) | 30 A |
| Dimensions (W x H x D) | 273 x 56 x 250 mm |
| Weight | 4.1 kg |
Observe instructions to prevent fires and personal injury, including cable gauge and heat precautions.
Follow instructions to keep the unit in proper working order, avoiding direct sunlight, water, and dust.
Follow steps for battery disconnection, input/output connection, ground, power, and final connection.
Illustrates connecting the amplifier to the center unit via RCA and power control leads.
Securely install the unit using tapping screws, avoiding damage to vehicle components during mounting.
The unit has a protection function to safeguard itself and speakers from accidents or problems.
Protection activates due to speaker ground contact, DC signal, overheating, or improper grounding.
Lists common issues like no sound, distorted sound, or beat noise and their potential causes.
Provides solutions for common problems, including checking connections and adjusting the 'Beat Canceler'.
To Next Page
