Need help?Do you have a question about the Kenwood KAC-PS200 and is the answer not in the manual?
Important safety measures to prevent fire, personal injury, and unit damage.
Guidelines for cleaning the unit and FCC compliance information.
Sequential steps for installing the power amplifier, including connection order and battery connection.
Critical warnings during installation to prevent short circuits and ensure proper function.
Details the accessories provided with the power amplifier for installation.
Identifies RCA input/output terminals and the RCA cable ground lead terminal.
Explains the function of the balance input and operation mode selection switches.
Identifies power control, speaker, ground, power terminals, and fuse location.
Controls for enabling and adjusting the low pass filter for frequency output.
Controls for adjusting input sensitivity and the power status indicator light.
Utilizing a balance converter for improved signal-to-noise ratio.
Example connection for using the LINE OUT terminal to link a second amplifier.
Configuration for outputting low frequencies, suitable for subwoofer systems.
Explains the amplifier's protection functions and the conditions that activate them.
How to set the operation switch to BRIDGED/L+R for increased output power.
Examples of single-unit high-power monaural and two-unit high-power stereo systems.
Caution regarding speaker impedance when bridging to prevent amplifier damage.
Method of dividing frequency bands using coils and capacitors for specific speaker outputs.
Formulas for calculating required coil and capacitor values based on crossover frequency and impedance.
Illustrates system connection for Tri-mode operation, including full-range speakers and subwoofer.
Warning about speaker impedance when bridging in Tri-mode to prevent amplifier failure.
Detailed instructions for connecting the center unit, RCA cables, and power control lead.
Guidelines for connecting battery, ground, and speaker cables, including polarity.
Important notes on grounding, power connection order, safety fuses, and noise reduction.
Recommendations for mounting the unit and selecting an optimal installation location for heat dissipation.
Cautions regarding heat build-up, cooling fan blockage, and secure installation to avoid interference.
Verifying the correct operation of vehicle electrical systems after unit installation.
Guide to resolving common issues like no sound, low output, poor quality, or beat noise.
Detailed technical data for KAC-PS200 and KAC-PS150 models including power, frequency response, and dimensions.
To Next Page
General