EasyManuals Logo

Kenwood KAC-PS702EX User Manual

Kenwood KAC-PS702EX
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
System
wiring
instructions
P-W121B
and
P-W101B
woofer
I
amplifier
packages.
Wiring
the
Amplifier
to
the
Woofer
enclosure.
Wire
the
Amplifier
in
the
bridged
configuration.
Bridged
Configuration
Wire
the
amplifier
according
to
the
instructions
provided. Use
the
bridged
connection
method
when connecting
the
woofer
enclosure
to
the
amplifier.
This uses
both
channels
of
the
amplifier
to
power
the
single
speaker providing
the
best
power
I
performance.
System
set
up
and
adjustments
Once connected, set
the
Filter.
to
LPF.
Using a
good music source, adjust
the
gain
to
match
the
bass
to
the
full
Range
speakers. Experiment
with
the
placement
of
the
enclosure. Sometimes
facing
the
enclosure
towards
the
back
of
the
~:ID(F
~@INE
IN
~
vehicle
can increase bass. /
@
2.1@·0.5
~m~
Set
this
switch
to
the
LPF
,M,~
:it~®~~~~;~~~~~~1
If
you
have
problems
or
questions
wiring, call
1-800-536-9663
KENWOOD
setting
(Low
Pass
Filter)
SEN~~'i'iv
1
v
1
@~;~
Adjust
the
gain
control
so
that
at full volume
the
woofer
doesn't distort.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood KAC-PS702EX and is the answer not in the manual?

Kenwood KAC-PS702EX Specifications

General IconGeneral
Amplifier class-
Frequency range20 - 50 Hz
High pass filterYes
Input sensitivity0.2 mV
Low pass filter range50 - 200 Hz
High pass filter range0 - 80 Hz
RMS output power (max)200 W
Speaker impedance range2 - 4 Ω
Signal-to-Noise Ratio (SNR)80 dB
Number of amplifier channels4 channels
RMS power output per channel (2 Ohm)60 W
RMS power output per channel (4 Ohm)40 W
Audio RCA inputs2
Housing materialAluminum
Weight and Dimensions IconWeight and Dimensions
Depth167 mm
Width230 mm
Height56 mm
Weight1400 g

Related product manuals