Need help?Do you have a question about the Kenwood KD-491F and is the answer not in the manual?
General| Type | Fully automatic turntable |
|---|---|
| Speeds | 33 1/3 and 45 rpm |
| Motor | DC servo motor |
| Effective length | 220 mm |
| Frequency response | 20 Hz to 20 kHz |
| Power supply | AC 120V, 60Hz |
| Cartridge | Moving magnet |
| Drive system | Belt drive |
| Platter | Aluminum die-cast platter |
| Tonearm | Static balance S-shaped tonearm |
Instructions for unpacking the unit and checking for damage.
How to set the AC voltage selector switch under the turntable.
Avoid objects falling into or liquid spilling into the unit.
Never remove the enclosure to avoid electric shock.
Do not use the unit near water or moisture.
Turn off power and unplug if abnormal smell or smoke is detected.
Conditions under which the unit requires servicing.
Refer servicing to qualified personnel.
Steps for installing the turntable platter and sheet.
How to connect the unit to the amplifier's PHONO MM jacks.
Step-by-step guide for automatic playback operation.
How to pause playback using the cueing lever.
How to fully stop playback using the PLAY/CUT key.
Step-by-step guide for manual playback operation.
Procedure for replacing the phono cartridge.
Procedure for replacing the stylus assembly.
Recommendation for periodic servicing and check-ups.
To Next Page
