Kenwood KRF-V5050D Instruction Manual

~~~f~nin~ to a su~m2 G~~~u#eni
..^
VOLUME CONTROL
INPUT SELECTOR
RC-RO511
RC-RO61 S/R061 7
a en;;; ;;;;;;ELECTOR knob to select the source you
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
VR-506lKRF46050D
g “;~~m;
“
0 “CDIDVD”
@ “TAPE” or “MD”
@ “VIDEOl”
if VlDEO2lMONlTOR is VIDEO2
@I “VIDEOZ”
8 “;;Dlll;”
“
I,
else if VIDE02/MONITOR is MONITOR
m “DVD/Gch”
L 8 “AV AUX”
KRF-V5050D
I
8 “Tpwill~~”
“ II
@ “CDIDVD”
@I “TAPE” or “MD”
0 “VIDEO1 ”
if VlDEOPlMONlTOR is VIDEO2
@ “VIDEOZ”
0 “DVDlGch”
else if VIDE02/MONITOR is MONITOR
@I “DVD/Gch”
VR-505
0 “AUX”
0 “TUNER”
0 “CDIDVD”
0 “TAPE” or “MD”
(!$j “VIDEOl”
if VIDE02/MONITOR is VIDEO2
g W;o2”
“ 91
else if VIDE02/MONITOR is MONITOR
@ “DVD”
VR-517IKRF45550D
r
0 “AUX”
0 “TUNER”
0 “CDIDVD”
@I “TAPE” or “MD”
0 “VIDEOl”
- if VIDE02/MONITOR is VIDEO2
0 “VIDEOS”
@I “DVD/Gch”
@ “AV AUX” (VR-517 only)
else if VIDE02/MONITOR is MONITOR
@ “DVD/6ch”
0 “AV AUX” (VR-517 only)
q Start playback from the selected source
m $et$V~LlfME CONTROL knob (VOLUME keys) to adjust
’ \
Selecting VlOEOZ/MONITOR
Depending on the component connected to the VIDEO 2/MONITOR
jacks, select either the “VIDEO 2” setting or the “MONITOR” setting, as
appropriate
-!a
Adjusting the sound
URCE DIRECT
PHONES (SPEAKERIMUTE) VOLUME CONTROL
RC-ROHl
Adjusting the tone
RC-R0615/R0617
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode
0 Press the SOUND key to select the tone mode to be adjusted
BASS: Select this to adjust the low frequency range
(Press the SOUND key once )
TREB: Select this to adjust the high frequency range
(Press the SOUND key twice )
0 Use the MULTI CONTROL keys to adjust the sound quality
l The bass and treble levels are adjustable from -1OdB to +I OdB in 2
step increments
l The adjustment item is di@ayad for approximately 8 seconds
Once-touch low frequency emphas% ibass’boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo modes
Press the B BOOST (BASS BOOST) key
l Press the key once to select the maximum (+lOdB) low frequency
emphasis setting
l This key does not function when the receiver is in the sound quality or
ambience effects adjustment mode
Switching back to the previous setting
Press the B BOOST (BASS BOOST) key again

Kenwood KRF-V5050D Specifications