Kenwood NEXEDGE NXR-700 User Manual

NXR-700/ NXR-800
© B62-XXXX-00 (E)
09 08 07 06 05 04 03 02 01 00
VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER
INSTRUCTION MANUAL
BASE-RELAIS NUMÉRIQUE VHF/ BASE-RELAIS NUMÉRIQUE UHF
MODE D'EMPLOI
BASE-REPETIDOR DIGITAL VHF / BASE-REPETIDOR DIGITAL UHF
MANUAL DE INSTRUCCTIONES
BASE-RIPETITORE DIGITALE VHF/ BASE-RIPETITORE DIGITALE UHF
MANUALE DI ISUTRUZIONI
VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER
BEDIENUNGSANLEITUNG
VHF DIGITALE BASIS REPEATER/ UHF DIGITALE BASIS REPEATER
GEBRUIKSAANWIJZING

Kenwood NEXEDGE NXR-700 Specifications

General

Frequency Range	136-174 MHz
Operating Voltage	13.6V DC ±15%
NXDN Air Interface	Yes
FM Analog Operation	Yes
Operating Temperature	-30°C to +60°C
IP Rating	IP54
Dimensions	483 mm x 44 mm x 350 mm
Modulation	16K0F3E

Summary

Precautions

Notices to the User

Unpacking and Checking Equipment

Installation

Controls and Functions

Front Panel

Overview of controls and indicators on the front of the repeater.

Rear Panel

Details of connectors and ports on the rear of the repeater.

Repeater Operation

Transceiver Operation

Receive

Instructions for receiving signals and adjusting volume.

Transmit

Steps for transmitting signals using the microphone.

FCC Warning

Information to the Digital Device User Required by the FCC

Terminal Description

MIC (Modular Jack)

Pinout and specifications for the microphone connector.

COM (D-SUB 9 Pin) CONNECTOR

Pinout and specifications for the serial COM port connector.

TEST/SPEAKER CONNECTOR

Pinout and specifications for test and speaker connections.

Control I/O (D-SUB 25 Pin) CONNECTOR

Pinout and specifications for the control input/output connector.

LAN (Modular Jack)

Pinout and specifications for the Ethernet LAN connector.

SYNC 1, 2 Connector

Pinout and specifications for the synchronous signal connectors.

Mandatory Safety Instructions to Installers and Users

Warning