Alternatively, on full key models, you can enter a unit ID directly by pressing the keypad.
●
Press the [ ] key to enter the manual input mode. Refer to “CHARACTER
ENTRY” {p. 19} .
Press the [ ] key to confirm the code after entering the code using the keypad.
To delete the code entered, press the [ ] key to delete one digit, or press and hold
the [ ] key to delete all digits.
3
Press and hold the PTT switch to make the call.
●
Speak into the transceiver as you would during a normal call.
●
The LCD display will return to the zone and channel screen after call ends.
o
Making Group Calls (NXDN Trunking)
You can select a channel with the Group ID you wanted to call to make a call to those
parties on a Trunking channel.
●
If the traffic channel is busy, a busy message appears and the busy tone sounds. Release
the PTT switch and wait for the channel to become free. When the traffic channel becomes
free, a proceed tone sounds.
1
Select the configured Group channel using the keys programmed as [Channel
Up]/ [Channel Down].
10
To Next Page
Loading...
Need help?
General
