Kenwood NX-5200 User Manual

2
Press the [J] and [K] keys to select a Group ID/ name from the list that has been
pre-entered into your transceiver.
3
Press and hold the PTT switch to make the call.
●
Speak into the transceiver as you would during a normal call.
●
The LCD display will return to the zone and channel screen after call ends.
o
Making Individual Calls (NXDN Conventional)
You can make calls to specific persons.
1
Press the key programmed as [Individual], [Individual + Short Message] or
[Individual + Status] to enter Individual Call Mode.
Alternatively, press the key programmed as [Menu] to enter Individual Call Mode using
the Menu Mode.
●
The ID list appears on the display.
2
Press the [J] and [K] keys to select a unit ID from the list that has been pre-
entered into your transceiver.
9

Kenwood NX-5200 Specifications

General

IP Rating	IP67
Zones	128
GPS	Yes
Bluetooth	Yes
Voltage Range	7.5V DC ±20%
Operating Temperature	-30°C to +60°C
Frequency Range	136-174 MHz
Battery Life	14 hours (Digital mode)
Digital Protocol	NXDN, DMR
Display	LCD