Configuration using KPG-D1/ D1N
Configuring Map Header
(
Transceiver Settings > Optional Features > Optional Features 2 > GPS > Base Station
Settings)
GPS Position Display
GPS Position Display is the function to display the current location information of the own transceiver on the LCD.
Refer to Common FUNC “USING THE GPS FUNCTION” for details about GPS Position Display.
1.18
Remote Operation by Radio Communication (Remote Control)
Remote Control is the function to remotely operate using radio communication the control of an individually specified
transceiver.
An individually specified transceiver can be controlled by sending various Remote Control messages and by making the
transceiver receive the messages.
Remote Control has the following functions:
Table 1-21 Remote Control Functions
Function Description
Remote Stun
This is the function to disable the use of an individually specified transceiver (Stun state) by making
the transceiver receive a Remote Stun message. If the transceiver receives the Remote Revive
message, the Stun state will be reset. (Refer to Disabling the Transceiver Capability by Remote
Control (Stun/ Kill).)
Remote Kill
This is the function to inhibit the use of an individually specified transceiver and disable all
operations by making the transceiver receive a Remote Kill message. (Refer to Disabling the
Transceiver Capability by Remote Control (Stun/ Kill).)
Remote Monitor
This is the function to make an individually specified transceiver transmit continuously by making
the transceiver receive a Remote Monitor message. (Refer to Monitoring the Situation Around
Another Transceiver by Remote Control (Remote Monitor).)
Radio Check
This is the function to check whether or not an individually specified transceiver is being operated
by
making the transceiver receive a Radio Check message. (Refer to Checking Whether Another
Transceiver Is in Operation (Radio Check).)
An individually specified transceiver can be controlled by sending various Remote Control messages in Remote Control
Mode and by making the transceiver receive the messages.
Pressing the Remote Control key places the transceiver in Remote Control Mode. Or, pressing the Menu key to enter
Menu
Mode and then selecting “Remote Control” places the transceiver in Remote Control Mode. (Refer to Common FUNC
Using Menu Mode.)
Also, various Remote Control messages can be sent by sending a transmission command of the various Remote Control
messages from a PC to the transceiver. In this case, “Data” or “Data + GPS Data Output” needs to be assigned to the
communication port of the transceiver.
Configuration using KPG-D1/ D1N
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
1 DMR CONVENTIONAL SYSTEM
1.17 Receiving GPS Data
DMR FUNC (K, F)/Ver 2.20 74
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
