How to fix Kenwood Transceiver if it will not turn on?
If your Kenwood Transceiver will not turn on, the battery pack may be discharged. Recharge the battery pack or replace the batteries. Alternatively, the battery pack may not be installed correctly; remove it and install it again.
What to do if I cannot hear other members on my Kenwood Transceiver?
If you cannot talk to or hear other members in your group using your Kenwood Transceiver, ensure you are using the same frequency and Common ID (Digital)/ QT/DQT (Analog) settings as the other members. Also, ensure that all group members are within range of each other.
Why is my Kenwood ProTalk Digital TK-3401D Transceiver battery life getting shorter?
Battery deterioration in your Kenwood Transceiver occurs when a battery pack is charged repeatedly because the battery pack life is finished. Replace the battery pack with a new one.
General| Frequency Range | 446.00625 - 446.09375 MHz |
|---|---|
| Channels | 16 |
| Power Output | 0.5W |
| IP Rating | IP54 |
| Audio Output | 1 W |
| Analog Modulation | FM |
List of do's and don'ts for safe transceiver operation.
Critical warnings for operating the transceiver in hazardous locations.
Critical warnings about battery disassembly, short-circuiting, and heat.
Critical warnings about battery piercing, dropping, and soldering.
Warnings about handling leaking batteries and abnormal battery behavior.
Steps to turn on the transceiver and set the volume level.
Steps for transmitting and receiving signals.
Guide to assigning functions to the Side 1 and Side 2 keys.
Procedure to enable and configure the hands-free VOX operation.
Procedure to restore all settings to factory defaults.
Solutions for problems with turning the transceiver on.
Troubleshooting battery issues from repeated charging.
Solutions for not being able to talk to or hear group members.
To Next Page
