A
Ashley TurnerJul 30, 2025
How to fix no sound from the speaker on Kenwood Transceiver?
- CChristopher LandryJul 30, 2025
If there is no sound from the speaker and no signal can be received on your Kenwood Transceiver, it could be due to several reasons: * The squelch might be closed. To resolve this, turn the SQL control counterclockwise. * If you're using a TSU-7, CTCSS might be active. Deactivate it by pressing the F key, then the 3 key. * DTSS might be operating. Turn it off by pressing the F key, then the 2 key. * Paging might be active. Disable it by pressing the F key, then the 1 key.