Need help?Do you have a question about the Kenwood TM-331A and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TM-331A |
| Category | Transceiver |
| Language | English |
Essential safety measures to prevent electrical hazards and damage.
Detailed technical specifications for various transceiver models.
Steps for installing the transceiver and its mounting bracket.
Guidelines for mobile installation, battery, and ignition noise.
Power requirements for fixed station operation.
Antenna selection and connection guidelines.
Explanation of front panel controls and keys.
Detailed operation of VFO, MR, and MHz keys.
Operation of Call, SHIFT/AL, and TONE/T.ALT keys.
Using REV/STEP and DRS/ALT key functions.
Explains the meaning of various indicators on the LCD display.
Details on rear panel jacks and microphone connector pinouts.
Initial setup for receiving signals and control adjustments.
How to select operating frequencies and frequency steps.
Setting VFO tuning range limits.
Continued procedure for setting VFO tuning range limits.
How the Auto Lock Tuning system works for specific models.
Cautions and steps for transmitting.
Resetting the microprocessor and special memory channel functions.
Information on what can be stored in memory and how to enter it.
How to enter and confirm odd split memory channels.
Storing data in Call Channel and recalling memory channels.
Types of scan operations available (Band, Programmable, Memory).
Setting Time Operated vs. Carrier Operated scan hold.
Procedures for programmable band scan and memory channel scan.
How to skip specific memory channels during scanning.
Monitoring a priority channel while operating on another.
Setting transmit/receive frequency offsets for repeaters.
How to reverse transmit/receive frequencies.
Using tone signals and CTCSS for repeater access.
Using the transceiver for telephone calls via autopatch.
Setting up an audible alarm for incoming signals.
Explanation of DRS, DRS/T.ALT, and Normal modes.
How to select the tone quality for recordings.
Setting the number of voice messages for recording.
Procedures for recording signals and microphone audio.
How to play back recordings and set up automatic recording.
Factory alignment and general service notes.
Guidelines for returning equipment for service or repair.
Table of symptoms, probable causes, and corrective actions.
How to install the optional CTCSS decoder unit.
Installation procedures for DRU-1 and RC-10.
Descriptions of various optional microphones and speakers.
Images and names of various optional accessories.
To Next Page
