To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TS-130S and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TS-130S |
| Category | Transceiver |
| Language | English |
Transmitter specifications such as power input, impedance, and frequency stability.
Receiver specifications including sensitivity, selectivity, and audio output capabilities.
Details of the AGC-type speech processor and its function in audio signal amplification.
Explanation of the single conversion PLL circuit and the transceiver's frequency system.
Description of the PLL circuit construction and frequency generation mechanisms.
General adjustments and required test equipment for the transceiver.
Initial control settings and preparation steps before performing adjustments.
Adjustment procedure for the RIT control and its effect on frequency.
Adjustment procedures for PLL bandpass filters A, B, and C.
Adjustment of IF amplifier stages for maximum audio output.
List of essential test equipment like VTVM, SSG, and oscilloscopes.
Adjustment procedure for the VCO oscillator level and frequency.
Procedure to minimize spurious signals from VFO MIX.
Adjustment of the IF trap for peak point and effect.
Adjustment of transmit and receive bandpass filters for optimal waveform.
Adjustment of the PLL-IF trap for optimal signal output.
