What to do if Kenwood TS-2000 Transceiver has low transmit power?
If your transceiver has low transmit power, first, if you are in SSB or AM mode, increase the microphone gain. Second, check antenna connections to confirm that the antenna tuner is reporting a low SWR, as poor antenna system connections can cause high SWR.
What to do if Kenwood Transceiver received signals are totally unintelligible?
If received signals are unintelligible, the wrong modulation mode may be selected. Press [LSB/USB], [CW/FSK], or [FM/AM] to select the correct modulation mode.
What to do if Kenwood TS-2000 will not power up?
First, ensure the DC power supply is switched ON. Inspect the power cable, confirming correct polarities (Red: positive (+); Black: negative (–)). Check that the connections to the DC power supply are secure. Finally, check the power cable fuse. If it's open, find the cause, correct any issues, and install a new fuse of the specified rating.
Why does Kenwood Transceiver reset to factory default?
If the internal TNC resets to the factory default values after switching ON the Kenwood Transceiver, the internal TNC backup lithium battery voltage is likely too low. Have a new battery installed by your dealer or at aKKKKKEEEEENNNNNWWWWWOOOOOOOOOODDDDDService Center.
Why does Kenwood TS-2000 Transceiver show 'HELLO' message when transmitting?
General| Antenna Impedance | 50 ohms |
|---|---|
| Supply Voltage | 13.8V DC ±15% |
| Current Drain TX | 20.5A |
| Receiver Type | Triple Conversion Superheterodyne |
| Modes | SSB, CW, AM, FM, FSK |
| Type | Base Station |
| Frequency Range TX | 0.1-60 MHz (HF), 144-148 MHz (VHF), 430-450 MHz (UHF) |
| Image Rejection | More than 70 dB |
| Selectivity | 2.4 kHz (SSB), 500 Hz (CW), 15 kHz (FM) |
| Antenna Connector | SO-239 |
| Frequency Range | HF/6m/2m/70cm |
To Next Page
