T
Tony HernandezSep 7, 2025
What to do if Kenwood TS-B2000 VOX does not operate?
- RRobert LopezSep 7, 2025
If VOX does not operate, the VOX gain may be set too low. Increase the gain via Menu No. 16.
To Next PageTo Next PageWhat to do if Kenwood TS-B2000 VOX does not operate?
If VOX does not operate, the VOX gain may be set too low. Increase the gain via Menu No. 16.
What to do if Kenwood Transceiver memory scan will not scan one of the stored channels?
If Memory Scan will not scan one of the stored channels, and the desired channel is NOT locked out, with Group Scan selected, the channel you want to scan may be in a different group. Select the group that contains the memory channel you want to scan.
Why Kenwood Transceiver no signals are received S-meter is reading full scale?
If no signals are received and the S-meter is reading full scale, the RF control may be set too low. Turn the RF control fully clockwise.
Why does Kenwood TS-B2000 Transceiver reset to factory default?
If the internal TNC resets to the factory default values after switching ON the Kenwood Transceiver, the internal TNC backup lithium battery voltage is likely too low. Have a new battery installed by your dealer or at aKKKKKEEEEENNNNNWWWWWOOOOOOOOOODDDDDService Center.
What to do if Kenwood TS-B2000 Transceiver tuning does not finish successfully?
If tuning does not finish successfully, the impedance of the coaxial cable and antenna may not be matched. Adjust the antenna system to lower the SWR.
What to do if Kenwood TS-B2000 internal tuner is bypassed immediately after tuning is started?
If the internal tuner is bypassed immediately after tuning starts, the SWR of the antenna system may be too high. Adjust the antenna system to lower the SWR.
What to do if Kenwood TS-B2000 program scan will not start scanning?
If Program Scan will not start scanning, the start and end frequencies may be identical. Store different start and end frequencies.
What to do if Kenwood TS-B2000 Transceiver memory scan will not start scanning?
If Memory Scan won't start, first, adjust the SQL control to just eliminate background noise. Second, ensure at least two memory channels are unlocked. Third, make sure data is stored in at least two memory channels.
Why Kenwood TS-B2000 Transceiver SSB audio quality is very poor?
Poor SSB audio quality may be due to several factors. First, check if the filter for digital operation is selected and, if so, change Menu No. 32 to OFF. Second, adjust the DSP SLOPE (LOW) control counterclockwise and the DSP SLOPE (HIGH) control clockwise. Third, ensure Noise Reduction 1 or 2 is OFF by pressing [N.R.]. Finally, verify Beat Cancel is OFF by pressing [B.C.].
Why Kenwood Transceiver frequency cannot be changed?
The Frequency Lock function may be ON. Press [F.LOCK] to switch OFF the function.
General| Brand | Kenwood |
|---|---|
| Model | TS-B2000 |
| Category | Transceiver |
| Language | English |
