Kenwood X-E5 - Page 27

ADJUSTMENT
PB level, REC level adjustment : Unit (X-E5), System (A-E5+X-E5)
* In the case of automatic adjustment (Self adjustment)
STEPS OF PROCEDURE
ADJUSTMENT RESULT
@ Lit (ON)
LED INDICATION STATE _ DISPLAY
X-E5
O FLICKERING _X (OFF)
AREEL LED | BREELLED /(System
L SIDE R SIDE|L SIDE|R SIDE} only)
| Under adjustment
Turn the power OFF or short pin 1 and pin 7 of CN9. (Unit)
When starting the self-adjustment of the unit (X-E5).
Connect AC16V (No.7 or No.8) and D17 (ANODE) of (X28 : AV6).
ALL OK
Turn the power OFF. ye] Ke oe Rare
Enter TCC-130 in DECK A and DECK B. PB CALBLch ERROR | O X Oo O- | PCLL
3 | Short circuit TP4 —P}- TP6 with diode and turn the power ON. PB CALB Rch_ ERROR Xx Oo | ‘e) e) PCLR
(The operation starts automatically.) A PB Lch ERROR o) x Oo | Xx
4 | DECKA playback level adjustment. A PB Rch ERROR | O xX Xx O- | APBR
5 | DECK B playback level adjustment. B PB Lch ERROR Xx Oo Oo x BPBL
6 {| Turn the power OFF. Breach _enror{| x | o | x | Oo | BPBR |
Enter TCC-106A in DECK B. REC CALB Lch ERROR Oo Xx X X RCLL
Short circuit TP4 —PI- TP6 with diode and turn the power ON. REC CALB RchERROR Xx Oo x Xx RCLR
(The operation starts automatically.) B REC Lch ERROR e) Oo Oo Xx BRCL
19 | Recording level adjustment. B REC Rch ERROR | O Oo X O |BRCR
Recording bias adjustment. B BIAS Lch ERROR Xx Xx Oo X BBSL
11] The adjustment is finished when the 4 light emitting diodes (LED) of BBIAS Rch _ ERROR x_| X x [| oO |[BBSR|
* | REEL are lit. The operation mode returns to normal when the power is PB ALL OK e ®
turned OFF or when the CCRS/CRLS key is pushed. (System) REC ALL OK Xx
e
*If the[CCRS/CRLS] key is pressed or No.1 and No. 7 of CN9 are shorted to each other, TEST 1 is selected.
x<
z
aa
i=
27