KEP BATCHtrol II - Page 19

15
3-10 Setup Procedure For The Batcher
3-10 Setup Procedure For The Batcher
(continued)
MENU ITEM 3
PRE TYP
This menu item is used to set up the Preset Type.
PRESS
DISPLAY
PRESET
↓
↓
PREWARN
↓
↓
PRE TYP
↓
↓
STD PRE
↓
↓
EZ PRE
↓
↓
Press D toggle between selections.
Enters displyed selection Run Mode
The PRE TYP is Set.
MENU ITEM 4
COUNT
Setting the Counter
PRESS
DISPLAY
PRESET
↓
↓
PREWARN
↓
↓
PRE TYP
↓
↓
COUNT
↓
↓
K FACTOR
K FACTOR fl ashes then shows the current K Factor.
Note: The K Factor setup is skipped if the unit has 16 Point option. The unit goes di-
rectly to R0 SP.
0 Flashes.
Clears out existing K FACTOR.
37.6 Flashes.
Sample K Factor, or enter calculated value from notes or worksheet.
continued on next page
D
D
D
ENT
ENT
D
D
D
ENT
D
CLR
3 7 D 6